Table of Contents
Advertisement
Trigger output
7.6
This signal can be used to trigger a camera. It can be used for pulse width
exposure control of the camera. The trigger timing for the light and camera can
be adjusted relative to each other.
This output is triggered at the same time as the light strobe output. The delay
and pulse width for this signal can be controlled independently of the light pulse.
7.7
Factory settings
The default VTR6 configuration for the light output and trigger output are:
•
•
•
•
•
•
Pulse operation
1ms pulse width
0.02ms delay
100% intensity
30ms retrigger delay
The configuration can be cleared to the default settings, by sending
the CL command.
18
Advertisement
Table of Contents
