Stihl HL 100 Instruction Manual page 28

English
Definitions
1. Loop Handle
For easy control of machine during
cutting work.
2. Carrying Ring
Connects the unit to the harness.
3. Slide Control
For starting throttle, run and stop.
Keeps the choke partially open
during starting and switches off the
ignition to stop the engine.
4. Throttle Trigger Lockout
Must be depressed before the
throttle trigger can be activated.
5. Throttle Trigger
Controls the speed of the engine.
6. Choke Knob
Eases engine starting by enriching
mixture.
7. Spark Plug Boot
Connects the spark plug with the
ignition lead.
8. Air Filter Cover
Covers and protects the air filter
element.
9. Fuel Tank
For fuel and oil mixture.
10. Machine Support
For resting machine on the ground.
11. Handle Hose
For holding and controlling the unit
with the hand during operation.
12. Fuel Filler Cap
For closing the fuel tank.
26
13. Carburetor Adjusting Screws
For tuning the carburetor.
14. Manual Fuel Pump
Provides additional fuel feed for a
cold start.
15. Starter Grip
The grip of the pull starter, for
starting the engine.
16. Muffler with Spark Arresting Screen
Muffler reduces exhaust noises and
diverts exhaust gases away from
operator. Spark arresting screen is
designed to reduce the risk of fire.
17. Cutting Blades
Steel blades for cutting hedges and
shrubs.
18. Blade Drive Gear
Converts rotary movement of angle
drive into reciprocating movement
of cutting blades.
19. Angle Drive
Transmits rotary movement of drive
shaft to the blade drive gear.
20. Drive Tube
Encloses and protects the drive
shaft between the engine and
gearbox.
21. Sliding Sleeve
Locks and unlocks the cutter bar
adjusting mechanism.
22. Adjusting Lever
Used to set cutter bar to the
required angle.
23. Quadrant
Locks the cutter bar in the required
position.
24. Blade Scabbard
Covers cutting blades when hedge
trimmer is not in use.
HL 100, HL 100 K