Additional Functionality; Setting The Countdown Timer; Activating The Child-Proof Lock; Releasing The Child-Proof Lock - Westinghouse WVE613 User Manual

USING YOUR OVEN (CONTINUED)
4. Touch the button as often as necessary, until the
'end time' symbol appears flashing.
5. Set the desired switch-off time using
the 'end time'
6. 5 seconds after the last change the 'cook time' and
'end time' arrows are lit to confirm that the oven has
been programmed.
7. When the delayed start cooking time has elapsed, a
signal will sound and the appliance will turn off. To
stop the signal, press any button on the clock and
then turn the oven function selector to OFF.
NOTE: Delayed start cooking time cannot be set for the
Rapid Heat function.
The feature can be cancelled at any time by returning the
function selector to OFF.

Additional Functionality

Setting the countdown timer

Use this for timing any activity. For example boiling eggs.
1. Touch the
2. Set the countdown time you want by using
. Commence with setting the number of seconds
first. The minutes and hours can then be set by
subsequently pressing the
adjusting using
change the timer will stop flashing, confirming the
timer has been set.
3. To cancel the timer touch the
will flash. Then touch and hold
until the timer is cleared.
4. To stop the beeper, touch any button.
NOTE: The clock display cannot be selected when the
timer is operating.
Elapsed Time
When an oven function is selected (other than pyrolytic
clean) an elapsed timer commences on the display.
To reset this timer touch and hold both the
buttons until the timer is reset.
Displaying the oven temperature
During operation of the oven the current oven
temperature during pre-heating of the oven can be
displayed by touching the
operation the set temperature can be reviewed by
touching the
NOTE: this temperature will only be displayed for
approximately 5 seconds.
Light operation
During operation of the oven the light can be switched
off by touching and holding the
24
USING YOUR OVEN
or
symbol is flashing.
button, the display will flash.
button again and
or . 5 seconds after the last
button, the display
and
button. During normal
button.
button until the
light turns off. Also the light can be turned on from the
standby state by touching and holding the
until the light comes on.
whilst

Activating the child-proof lock

When the child lock is engaged, the oven cannot be
operated and the door cannot be opened.
1. Switch off the appliance using the function
selector switch.
2. Touch and hold the
time until the word 'SAFE' is displayed and a double
beep is sounded. The word SAFE will be replaced by
a padlock symbol on the display after 5 seconds.

Releasing the child-proof lock

Touch and hold the
time until a double beep is sounded. This will commence
to unlock the door and after 5 seconds the oven is ready
for use.
Activating the function lock
The active function can be locked so it is not changed
and
unintentionally.
1. The active function can be locked, to activate touch
and
2. If the oven is switched off while in 'Loc' it will switch
into Child lock mode and the display will show 'SAFE'.
3. Oven can be released the same way as 'Releasing the
child proof lock'
buttons
Safety Cut-out feature
The oven automatically switches itself off if the
temperature is not adjusted or the appliance is left
operating after a period of time. The oven switches itself
off after:
• 12.5 hours when the temperature is set less than
120°C.
• 8.5 hours when the temperature is set to 120°C
or above, and below 200°C.
and
• 5.5 hours when the temperature is set to 200°C or
above, and below 250°C.
• 3.0 hours when the temperature is set at 250°C.
DEMO Mode
The oven can be set to operate in a demo mode (e.g. in a
retail store). In this mode the display works and functions
can be set but the oven does not actually heat. When
in this mode the text 'DEMO' will be lit. The following
instructions show how to enter and exit 'Demo' mode.
1. Ensure the oven is in the off state. Toggle and hold
the selector to
text will begin to flash.
2. Toggle the temperature selector to set the first digit
of display to 2. Touch clock to set.
and buttons at the same
and buttons at the same
together until 'Loc' is displayed.
until a beep sounds. The 'DEMO'
button