Table of Contents
Advertisement
Figure 39
1. Battery cover
4.
Disconnect the negative (black) ground cable
from the battery post
Note:
Retain all fasteners.
5.
Slide the rubber cover up the positive (red)
cable.
6.
Disconnect the positive (red) cable from the
battery post
(Figure
Note:
Retain all fasteners.
7.
Remove the battery hold-down
lift the battery from the battery tray.
Figure 40
1. Battery
2. Negative (–) battery post
3. Bolt, washer, and nut for
the negative (–) battery
post
4. Bolt, washer, and nut for
the positive (+) battery
post
2. Fasteners
(Figure
40).
40).
(Figure
40), and
5. Positive (+) battery post
6. Terminal boot
7. Battery hold-down
Charging the Battery
Service Interval: Before storage—Charge the battery
1.
Remove the battery from the chassis; refer to
Removing the Battery (page
2.
Charge the battery for a minimum of 1 hour at
6 to 10 A.
Note:
Do not overcharge the battery.
3.
When the battery is fully charged, unplug
the charger from the electrical outlet, then
g297596
disconnect the charger leads from the battery
posts
(Figure
1. Positive (+) battery post
2. Negative (–) battery post
Installing the Battery
1.
Position the battery in the tray
2.
Using the fasteners previously removed, install
the positive (red) battery cable to the positive
(+) battery terminal.
3.
Using the fasteners previously removed, install
the negative battery cable to the negative (-)
battery terminal.
4.
Slide the red terminal boot onto the positive
(red) battery post.
5.
Secure the battery with the hold-down
40).
g297597
6.
Install the battery cover by pushing down and
tightening the 2 fasteners clockwise
37
and disconnect the battery cables.
36).
41).
Figure 41
3. Red (+) charger lead
4. Black (–) charger lead
(Figure
g000538
40).
(Figure
(Figure
39).
Advertisement
Table of Contents
