Pushing The Machine By Hand - Toro Titan 5400C Operator's Manual

Pushing the Machine by
Hand
Important:
Always push the machine by hand.
Do not tow the machine, because towing may
damage it.
Pushing the Machine
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Locate the bypass levers on the frame on both
sides of the engine.
4. Move the bypass levers forward through the key
hole and down to lock them in place
Note:
Do this for each lever.
5. Disengage the parking brake.
Figure 27
1. Bypass-lever locations
2. Lever position for
operating the machine
6. When finished, engage the parking brake.
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
(Figure 27).
g298692
3. Lever position for pushing
the machine
Figure 27.
28