Initial Operation; Unpacking And Checking; Installation; Powering The Equipment - EMC-PARTNER AVI3000 User Manual

2 Initial Operation

2.1 Unpacking and Checking

1. Check the packaging for signs of damage. If damage is visible, report this to the shipping company
immediately.
2. Gently remove the equipment from the packaging.
3. Check the delivery for completeness using the delivery note and the accessory lists for the var-
ious items. If something is missing, contact EMC PARTNER or your local sales representative
immediately.
4. Check the equipment for any damage. If there is damage, immediately contact the shipping
company who made the delivery.
Retain the original packing material for a safe transport at a later date.

2.2 Installation

The equipment is designed for use under laboratory conditions. Make sure that all fan openings are
unobstructed, that the airflow perforations are unimpeded, and that the minimum distance from the wall
is 10cm. An insufficient airflow can cause the equipment to overheat, which may disturb the operation
and even cause damage.
Most equipment from EMC PARTNER can be mounted in a 19" Rack. A special rack mounting
kit is available. Contact your local sales company for a quotation.

2.3 Powering the Equipment

Check that the local AC-supply is suitable for the equipment. Power rating of the instrument is indicated
on the type plate next to the AC power supply connector located on the rear panel. Only use the supplied
power cord to connect to your public power supply.
The equipment must always be connected to protective earth. Check the earth connection on
your power outlet before you connect and turn on the equipment.

2.4 Safety Circuit

The Generator is equipped with a Safety Circuit. As long as the safety circuit is open, no test can be
started. To close the safety circuit
1. connect the auxiliary Connector on the rear panel
2. pull out the emergency stop button on the front panel with a slight turn clockwise
A closed safety circuit is indicated by a red illuminated emergency stop button
2 Initial Operation
Page 10/45