Table of Contents
Advertisement
Frame Construction
4. Remaining Internal Frames and Front Frame.
•
Secure the remaining internal frames in the same
manner as before. Checking everything is straight
and square as you go.
•
Connecting the side wall girts
to front frame requires the
tabs be bent at a right angle
just like we did before with
the rear frame.
•
Do not fit the centre mullion
cap until after the roller doors
have been installed.
5. Fit Strapping
•
Using a tape measure the roof diagonal dimension
to make sure that the frame is exactly square.
•
Fit the strapping (FAST040) diagonally over the
top of the frame from corner-to-corner, pulling
tightly and securing with three screws at every
point that the strapping crosses the internal
frames.
•
Repeat this procedure for
the rear frame
Absco Industries
Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG60602N2
6.00mW x 6.00mD x 3.40mH
Model: RG60602N2
22/10/19
18
Advertisement
Table of Contents
