ABSCO SHEDS RG60602N2 Manual page 15

Anchoring Layout
C0100
C0100
This image only shows the bottom of the frames and is not to scale.
• Fasten the multipurpose brackets (BKT17) to the
frames as shown above while they are laying on
the ground.
• Front and Rear frames will also require the C0100
be boxed into the bottom of both columns.
• Mark out the frame positions according to page
14. Misalignment between frames will result in the
wall girts not fitting properly.
• Secure with tek screws, refer to the engineering
drawing for the quantity of teks per bracket.
• When securing the BKT17 to the slab always use
the bracket hole that is furtherest away from the
slab edge. This will prevent the possibility of the
concrete cracking near the slab edge.
Absco Industries Assembly Instruction Manual
ABSCO GARAGE
MODEL: RG60602N2
6.00mW x 6.00mD x 3.40mH
Rear frame
Front frame
Model: RG60602N2
C0100
Internal frame 3
Internal frame 2
Internal frame 1
22/10/19
C0100
15