Table of Contents
Advertisement
STEP 2: Installing the vent pipe & liquid drain
EcoFlo
After selecting the toilet's location, place the 50mm DWV PVC pipe through the 50mm Wal-
lace seal in the back of the pedestal. Push the pipe flush against the wall the toilet will back
onto (in the correct alignment). Use the PVC pipe to mark a circle on the wall as a guide.
Keeping the fibreglass bottom in the same position, put the 19mm liquid drain hose inside the
fibreglass bottom and push the end without the connector through the small hole at the rear of
the shell. Using this hose as a guide, mark a circle around the hose as close to the floor as
possible.
Using the circles drawn on the wall as a guide, cut a hole of sufficient size to allow the 50mm
DWV PVC pipe to push through the wall and a second hole (approximately 25mm) for the liq-
uid drain hose.
Page 6
IMNL-003.181008
© Ecoflo Wastewater Management Pty Ltd
Advertisement
Table of Contents
