Table of Contents
Advertisement
Place the lid onto the chamber bottom and fasten in place with the bolt and wing nuts at the
back corner of the chamber. Remember, there will be one less chamber lid than compost
made from UV resistant plastic and come with a 10 year warranty.
Ensure the valve is open by turning it to be parallel with the direction of the drain hose. Push
the chamber as far forward as possible so the rim of the compost chamber is touching the front
of the fibreglass bottom.
As with every new compost chamber, layer the bottom of chamber with 25mm of bulking mate-
rial (coarse mulch that will not fall through the holes in the floor).
The shell top can now be placed onto the base. Do not glue the top to the base as it will need
to be removed from time to time to rotate the chambers.
IMNL-003.181008
chamber bottoms (i.e. the 'in-service' chamber will not have a lid
whilst it is in-use).
For the 'out-of-service' chambers with lids, push the 40mm re-
movable breather cap (unthreaded) into the 40mm socket
screwed into the rear of the chamber. This completes the 'out-of-
service' arrangement which should prevent the entrance of in-
sects whilst allowing air to ciculate through the compost when
the chamber is composting outside.
Once assembled you can store these chambers wherever is con-
venient whilst the first chamber is in use. The chambers are
If you have completed Steps 1-5 you
are now ready to use your toilet!
After 5 days add half a pack of Nature Quick microbes to the cham-
ber. Follow the instructions on the pack and use the other half in 2
© Ecoflo Wastewater Management Pty Ltd
1.Place the 'in-service' chamber (no
lid or 40mm breather cap) into the
base of the toilet shell.
2. connect the liquid drain valve at
the rear of the chamber to the liquid
drain hose.
weeks.
Page 15
Advertisement
Table of Contents
