Advertisement
18 | Assembly Required
2
For connecting the mast
wires, it is recommended
that you install the mast on
the mast ball located on the
front crossbar. Once you
place the mast on the ball
install the stepper bolt.
2
Place the thimble of the shroud
between the adjuster plate and insert
a clevis pin through the plate and
thimble. Then fasten with the ring.
3
Using a clevis pin and ring, connect the
adjuster plate to the shroud mounting
plate.
4
Pull the rubber boot cover down over the
top of the shroud attachment assembly.
Advertisement
