Install Properly; Level Refrigerator-Freezer; Remove Sales Labels; Clean It - Whirlpool ETWM ws Use & Care Manual

Install properly.. . Remove sales labels.. .
0
r-
I I
I/
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall.
3. Allow J/Z Inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
Level refrigerator-freezer.. .
1. Keep the 4 bolts that hold refrigerator In shipping
crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator. Roll refrigerator
into place.
3. Lower legs just enough to lift rollers off floor.
4. Adjust each until the refrigerator won't rock.
5. Adjust front legs to level the refrigerator.
-To raise corners, turn legs counterclockwise.
-To lower corners, turn legs clockwise.
6. Check with level.
4
Remove the Consumer Buy Guide label, tape and
any inside labels before using the refrigerator
To remove any remaining glue:
I. Rub briskly with thumb to make a ball then remove
OR
2 Soak area with dishwashing detergent solution (1
teaspoon detergent in 1 quart warm water) before
removing glue as described in step 1.
DO NOT USE rubbing alcohol or flammable or
toxic solvents, such as acetone, gasoline, car-
bon tetrachloride, etc. These can damage the
material.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
A -' f
Clean your refrigerator before using it. See clean-
ing instructions on pages 7 and 8.
Plug it in...
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused
and properly grounded electrical supply IS re-
quired. It IS recommended that a separate circuit
serving only this appliance be provided.
Do not use an extension cord. Use a recep-
tacle which cannot be turned off with a switch
or pull chain. See individual electrrcal requrre-
ments and grounding instruction sheet in your Irter-
ature package.