Adjusting The Refrigerator Shelves; And Crisper Cover; Changing The Light Bulb; Ice Cube Trays - Whirlpool ETl8SK Use And Care Manual

Adjusting the refrigerator shelves...
To remove the shelf:
1.
First, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lifl front, slide shelf the rest of the way out.
To
replace the shelf:
1.
Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf in until it clears guide stops.
.,. m--n**,, ..,.. 8, -*~*I.-. %i:'p*7L.$tl ,=,c -,. .I
Removing the crisper, trivet
and crisper cover...
To
remove the crisper:
1.
Slide crisper straight out to stop, lift front, then
slide the rest of the way out.
2. Replace in reverse order.
To
remove trlvet:
1.
Lift the trivet from the support brackets on the
back wall.
UT TO STOP.
E FRONT AND PULL AGAIN.
2. Replace in reverse order.
To remove the cover:
1. Lift front, then back.
2. Pull up and out.
To replace the cover:
1.
Fit notches on back of cover
back wall of refrigerator.
2. Lower front into place.
into supports on
Changing the light bulb...
1.
Reach behind the control console to find bulb.
2. Remove bulb.
3. Replace with a 40-waft appliance bulb.
Ice cube trays...
If cubes are not used, they may shrink. The mov-
ing cold air starts a slow evaporation. The longer :
cubes are stored, the smaller they get
To
remove ice:
1.
Hold tray at both ends.
2. Slightly twist
Optional automatic ice maker...
If you have the automatic ice maker accessory,
or if you plan to add one later (Part No. ECKMF-83)
there are a few things you will want to know:
l
The ON/OFF lever is a wire signal arm.
Down...for making ice automatically.
Up...to shut off the ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
6