Disassembling V-Drive For Transportation; Handling V-Drive When Not In Use - Vermeiren V-Drive User Manual

EN
NL
9
3.1.4 Installing the battery pack
1. Place the battery pack into the battery tray as shown in the
photo.
2. Secure the battery pack by pushing it all the way in. An audible
click will be heard.

3.2 Disassembling V-Drive for transportation

The battery supplied with the V-Drive is classified as safe for air travel in compliance with
IATA special provision A67.
Switch off the V-Drive.
1.
Disconnect the V-Drive module from the operating console
2.
(§3.1.3, 11).
Remove the lifting strap from the push handle (§3.1.3, 12).
3.
Remove the battery pack from the tray by pulling the handle of
4.
the battery pack and simultaneously pressing the PUSH button
at the bottom of the battery pack (13).
Pull up the strap (§3.1.2, 6) to unlock the telescopic bar (§3.1.3,
5.
8). Hold V-Drive and push the wheelchair forward a bit so the
telescopic bar comes out of the brackets. Remove the V-Drive
module from the wheelchair.
Place all items in the supplied carry holdall to prevent them from getting damaged.
6.
If necessary/desired, you can now fold the wheelchair for transportation.
7.
3.3

Handling V-Drive when not in use

When you want to push the wheelchair manually and do not wish to use
V-Drive, restrain the V-Drive module off the ground by lifting the red loop
on the lifting strap and placing it on the push handle.
8
10
6
Using V-Drive
12
11
13
V-drive
2020-05