Changing The Blade; Storage - Grizzly ARM 4038 Lion-Set Translation Of The Original Instructions For Use

or plastic to remove adherent plant
remains from the wheels, ventilation
holes, ejection hole and blade area.
Do not use hard or pointed objects, as
these may damage the blade.
• Oil the wheels from time to time.
• Before each use, check the lawnmo-
wer for obvious defects such as loose,
worn or damaged parts. Check that all
nuts, bolts and screws are sitting firm-
ly.
• Check the covers and protective de-
vices for damage and check that they
are sitting correctly. Replace them if
necessary

Changing the Blade

If the blade is blunt, it can be sharpened
by a specialist workshop. If the blade is
damaged or showing signs of imbalance,
it must be replaced
1. Turn the equipment over.
2. Use sturdy gloves and hold
the blade firmly (21). Turn the
blade screw (20) anticlockwise
off of the motor spindle using a
screwdriver.
3. Install the new blade (21) in the
reverse order. Ensure that the
blade (21) is positioned correct-
ly and the screw (20) tightened
firmly.

Storage

Release the upper and lower
quick-release levers (2 + 5) and
fold the bow-type handle (1) and
lower bar (4) together so that the
device takes up less space. Ensu-
re that the cables are not jammed
in the process.
• Keep the equipment dry and out of
reach of children.
• Allow the motor to cool before storing
the equipment in a confined space.
• Remove the batteries from the device
before a lengthy storage period (e. g.
overwintering).
• Only store the batteries in the parti-
ally-charged state. The charge level
should constitute 40-60% during a
lengthy storage period (two LED lights
illuminated on the charge level indica-
tor
( 7a).
• Check the battery charge level ap-
proximately every 3 months during a
lengthy storage period and recharge if
necessary.
• Store the batteries between 10° C
and 25° C. Avoid extreme cold or heat
during storage, lest the batteries lose
power.
We will not be liable for damages caused
by our equipment where these are
caused by improper repair or the use of
non-original parts or by use other than for
the intended purpose.
GB
37