Used Batteries; Working With The Lawnmower; Cleaning, Maintenance And Storage; General Cleaning And Maintenance Work - Grizzly ARM 4038 Lion-Set Translation Of The Original Instructions For Use

GB

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
The first cut is to be made in around April,
at a growth height of 70 – 80 mm. In the
main vegetation period, the lawn is to be
mowed at least once a week.
• Run the equipment at a walking pace,
in tracks that are as even as possib-
le. For gap-free mowing, the tracks
should always overlap by a few cen-
timetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each
use, as described in the chapter on

"Cleaning, Maintenance and Storage".

36
Switch off the equipment after
work and in order to transport
it, disconnect the plug and wait
until the blade stops. There is a
risk of injury.
Cleaning, Maintenance
and Storage
Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade
Switch off the device, pull the con-
tact chip (
blades to come to a stop. There is
a risk of personal injury.
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
General Cleaning and
Maintenance Work
Do not hose down the lawnmo-
wer with water. Electric shock
hazard
• Always keep the equipment clean. To
clean, use a brush or cloth but no de-
tergent or solvent.
• After mowing, use a piece of wood
17) and wait for the