Electrical connection
Electrical connection
Electrical connection
Electrical connection
WARNING:
WARNING:
WARNING:
WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock!
shock
shock
shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• If possible, the accessibility of the power plug
must be ensured to disconnect the appliance from
the power supply in case of emergency.
CAUTION
CAUTION: : : :
CAUTION
CAUTION
In case you disconnect the appliance or in case of
power failure; wait for approx. 5 minutes before re-
starting and check the operation settings.
• Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
• Connect the mains cable to a properly installed
and earthed wall outlet.
Reverse the door o
Reverse the
door opening
pening
Reverse the
Reverse the
door o
door o
pening
pening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
WARNING:
WARNING:
WARNING:
WARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply. Always unplug
the appliance first.
NOTE: : : :
NOTE
NOTE
NOTE
• When installing, ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
electric
electric
electric
screw wrench, Phillips screw-
• Dismount the upper limit plate incl. hinge pin by
loosening the screws. Open the door a little and
take it carefully off the lower door hinge. Place the
door on a padded surface to prevent it from
scratches.
• Tilt the appliance slightly backwards and block it
in this position. Loosen the lower hinge pin and
put it in the opposite bracket.
• Replace the appliance upright again. Insert the
appliance door on the lower hinge pin and fix the
door to the property position.
• Attach the upper limit plate after you have un-
screwed the hinge pin and used it on the other
side of the plate. Insert the hinge pin in the hole of
the appliance door and tight the plate.
• Check if the door is arranged vertical as well as
horizontal, so that a smooth opening and closing
of the door is ensured.
Reverse the freezer door opening
Reverse the freezer door opening
Reverse the freezer door opening
Reverse the freezer door opening
• Open the freezer door a little. Using a small
screwdriver, press the spring of the lower bracket
slightly upwards and remove the holder together
with the freezer door.
• Position the blind cap (M) on the opposite side.
• Turn the freezer door about 180° and press the
lower bracket into the appropriated fixture of the
freezer compartment.
• Lift the freezer door slightly a little and attach it to
the upper bracket, simultaneously press the lower
bracket into the square hole. Small adjustments
up and down facilitate the attachment of the
freezer door.
19