Removing The Crispers And Crisper Covers; Changing Light Bulbs; Reversing Door Swing; Ice Cube Troys - Whirlpool ET22MK Use & Care Manual

Removing the crispers and
crisper covers.. .
l
Slide crispers straight out to stop
l
Lift the front
l
Slide the rest of the way out.
l
Replace In reverse order
Covers are held In place by two pegs at the back
and two notched tabs in front.
Push the Tab
to Clear the Cover.
Snap Back into Place.
l
Press front tabs out of the way
l
Lift cover front.
l
Lift back off the pegs.
l
Replace In reverse order.
The center leg can be made shorter or longer to
help level the crisper covers, If necessary. Turn the
leg clockwise to make It longer. Turn It counter-
clockwise to shorten It
Changing the light bulbs...
Before removing the light shield for cleaning or for
replacing the bulb. unplug the refrigerator. Use
OppiionCe
bLJ/bS
On/y
Push in the Center;
light bulb behind light shield:
l
Push lightly on the top center of the light shield
until the notched tab unhooks from the control
panel.
l
Pull down on the shield until the tab clears the
control panel.
l
Lift the back hooks out of their slots.
l
Replace with a 40-watt appliance bulb
l
Replace light shield in reverse order.
Light bulb behind crispers:
l
Remove crispers and crisper covers.
l
Bulb is on back wall of refrigerator.
l
Replace with a 40.watt appliance bulb.
l
Replace crisper and crisper cover.
l
Plug In the refngerator.
Reversing the door swing.. .
You can change the hinges on your refrigerator SO
the doors open the other way. Refer to the instruction
sheet Included with your refrigerator
Ice cube trays.. .
To remove ice:
l
Hold tray at both ends.
. Slightly twist
If cubes are not used, they may shrink. The moving
cold air starts a slow evaporation. The longer cubes
are stored, the smaller they get.
Optional automatic ice maker.. .
On
I
L
Raise Signal
\
Arm to Stop Ic
L
Lower Signal
Arm to Start It.
L
e Maker.
If you have the automatic ice maker accessory or
plan to add one later (Part No. ECKMF-6). there are
a few things you will want to know,
l
The ON/OFF lever is a wire signal arm.
Down.. foe making Ice automatically.
Up...toshut off the ice maker.
l
Shake the bin occasionally to keep cubes sepa-
rated, and to obtain Increased storage capacity.
l
It is normal for Ice crescents to be attached by a
corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You'll hear Ice fall Into the bin. Don't let
these sounds bother you.
l
The ice maker will not operate until the freezer IS
cold enough to make ice. This can take overnight.
l
Because of new plumbing connecttons, the first
ice may be discolored or off-flavored Discard the
first few batches of ice
l
If ice IS not being made fast enough and more Ice
IS needed, turn the Temperature Control toward a
higher number. Wait a day and, If necessary, turn
the Air Control toward A.
l
If you remove the Ice bin, raise the signal arm to
shut off the Ice maker. When you return the bin.
push it all the way In and lower the arm to the ON
position.
l
If cubes are stored too long, they may develop an
off-flavor. .Ilke stale water. Throw them away They
~111 be replaced Cubes in the Ice bin can also
become smaller by evaporation.