4. Controls, Indicators, and
Connections
Event Marker
Push Button
Power, Active, and
Remote LEDs
Bulkhead Mounting
Ear
Mini-B
USB Connection
Please note: The SD card slot is not used in the DI-1100. Allowing foreign materials to enter the device through the
SD card slot may result in damage to the instrument.
Mini-B USB Connection
Use the supplied USB cable to connect and power the instrument through your computer's USB port.
Connect Input Signals
Make input signal connections to the 16-port screw terminals. Each terminal is labeled directly on the instrument
case.
DI-1100 Signal Connections
Refer to the following for screw terminal port identification.
Ch#: Analog channels 1-4 (±10VFS, ±100V transient Max.)
Remote Control Event: Digital Input bit 0—Remote Event Marker
Remote Control Record: Digital Input bit 1—Remote Start/Stop
Reserved NC: No connection—reserved.
Model DI-1100
Event
Data Acquisition Starter Kit
Power
Active
www.dataq.com
Remote
Analog Inputs (±10 VFS, ±100 V max.)
Ch1
Ch2
Ch3
Ch4
-
-
-
+
+
+
+
Analog In
Channels 1-4
(no connection)
Model DI-1100
Event
Data Acquisition Starter Kit
Power
Active
www.dataq.com
Remote
Analog Inputs (±10 VFS, ±100 V max.)
Ch1
Ch2
Ch3
Ch4
-
-
-
-
+
+
+
+
Controls, Indicators, and Connections
Download software
at run.dataq.com
Reserved
Remote Control
Event
Record
-
-
-
+
+
Reserved
Digital In
Channels
Download software
at run.dataq.com
Reserved
Remote Control
Event
Record
-
+
+
7
DI-1100 Hardware Manual
SD Card Slot
(not used in DI-1100)
Bulkhead Mounting Ear
-