VAT 264 Series Installation, Operating, & Maintenance Instructions
Dn 63 (i.d. 2 1/2")
Hide thumbs
Also See for 264 Series:
Table of Contents
Advertisement
Quick Links
HV Angle valve
● with pneumatic actuator,
single acting with closing spring (NC)
This manual is valid for the valve ordering number(s):
264...
The fabrication number is indicated on each product as per the label
below (or similar):
made in Sw itz erland
Fab rication No .:
patented
26. . . – . . . . – . . . . / . . . .
A – . . . . . .
Explanation of symbols:
Read declaration carefully before you start any other
action!
Attention!
Product is in conformity with EC guidelines,
if applicable!
Disconnect electrical power and compressed air
lines. Do not touch parts under voltage!
Read these «Installation, Operating & Maintenance Instructions» and the enclosed «General
Safety Instructions» carefully before you start any other action!
Imprint:
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Manufacturer
Website
www.vatvalve.com
VAT Vakuumventile AG, CH-9469 Haag, Switzerland
Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com
Installation, Operating & Maintenance Instructions
Series 264, DN 63 (I.D. 2
(Series 264)
. .
Fabri cation number
Phone
+41 81 771 61 61
1
/
")
2
Keep body parts and objects away from the valve
opening!
Hot surfaces; do not touch!
Loaded springs and/or air cushions are potential
hazards!
Wear gloves!
Fax
+41 81 771 48 30
285679EA
2010-09-01
Email
CH@vatvalve.com
1/12
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for VAT 264 Series
Summary of Contents for VAT 264 Series
- Page 1 Wear gloves! lines. Do not touch parts under voltage! Read these «Installation, Operating & Maintenance Instructions» and the enclosed «General Safety Instructions» carefully before you start any other action! Imprint: VAT Vakuumventile AG, CH-9469 Haag, Switzerland Manufacturer Website Phone Email www.vatvalve.com...
- Page 2 VAT products. The VAT firmware contains a limited, time unlimited user license. The VAT firmware may not be used for purposes other than those intended nor is it permitted to make copies of the VAT firmware. In particular, it is strictly forbidden to give copies of the VAT firmware to other people.
-
Page 3: Table Of Contents
5.1.3 Mount "actuator/plate assembly" ......................10 6 Drawing................................... 10 7 Spare parts ................................11 8 Warranty ................................. 12 VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 3/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com... -
Page 4: Use Of Product
") Use of product Use product for clean and dry indoor vacuum applications under the conditions indicated in chapter «Technical data» only! Other applications are only allowed with the written permission of VAT. Technical data for standard valve Leak rate... -
Page 5: Installation
«F » lbf . ft inch A combination of both forces «F » and «M» is prohibited. Please contact VAT. Connections 2.3.1 Compressed air connection Connect compressed air only when - valve is installed into the system - moving parts cannot be touched The valve is closed by a spring at compressed air failure. -
Page 6: Electrical Connection
Lagemelder "geschlossen" Indicateur de position "ouvert" Indicateur de position "fermé" Indicateur de position "ouvert" Indicateur de position "fermé" VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 6/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com 2010-09-01... - Page 7 Lagemelder "geschlossen" Indicateur de position "ouvert" Indicateur de position "fermé" Coil solenoid valve Spule Steuerventil Bobine de l'électrovanne VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 7/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com 2010-09-01...
-
Page 8: Operation
Connect correct air pressure If you need any further information, please contact one of our service centers. You can find the addresses on our website: http://www.vat.ch VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 8/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com... -
Page 9: Maintenance & Repairs
Contamination from the process may influence the function and requires more frequent maintenance. Before carrying out any maintenance or repairs, please contact VAT. It has to be individually decided whether the maintenance/repair can be performed by the customer or has to be carried out by VAT. The fabrication number on the valve made in Switzerland Fabrication No.:... -
Page 10: Mount "Actuator/Plate Assembly
• Fasten 4 screws (60) uniformly and crosswise in 2 to 3 steps • Perform function and leak test Drawing VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 10/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com... -
Page 11: Spare Parts
110-115 VAC / 60 Hz 200 VAC / 50-60 Hz 220-230 VAC / 50 Hz 220-230 VAC / 60 Hz VAT Vakuumventile AG, CH-9469 Haag, Switzerland 285679EA 11/12 Tel +41 81 771 61 61 Fax +41 81 771 48 30 CH@vatvalve.com www.vatvalve.com... -
Page 12: Warranty
(including any delay in or failure to deliver), packaging, storage or use of any product sold or delivered by VAT shall fail to conform to the...
Need help?
Do you have a question about the 264 Series and is the answer not in the manual?
Questions and answers