Installing The Solera Slide Topper Access Bracket - Lippert Components Solera Slide Topper with Access Plates Installation And Owner's Manual

NOTE: There might be a slight gap between the T-molding
side and the side of the mounting bracket
(Fig.8C) if the corner does not have a 90 degree angle.
B. If installing on the T-molding, start on one side of
the front of the slide-out by placing one of the two
access brackets (Fig.9A) at the very bottom corner of the
T-molding, (Fig.9B) as close to the outside of the T-molding
as possible without going over the corner mold (Fig.9C).
NOTE: Make sure the screws do not go over the roof line.
C
B
Fig.9
2. Fasten the mounting bracket to the slide-out exterior wall
using the five provided #10 -13 x 1
head screws (Fig.10).
Fig.10
lci1.com
A
1/4
" recessed square
574-537-8900
Solera Slide Topper
®
with Access Plates
Installation and Owner's Manual
(For Aftermarket Applications)
FALLING SLIDE TOPPER ACCESS BRACKETS
CAN CAUSE PERSONAL INJURY, PRODUCT AND/
OR PROPERTY DAMAGE. SLIDE TOPPER ACCESS
BRACKETS ARE INSTALLED LOOSE ON THE ACCESS
PLATE UNTIL FINAL INSTALLATION. MAKE SURE
ACCESS BRACKETS ARE SECURE ENOUGH TO
PREVENT FALLING FROM THE ACCESS PLATE.

Installing the Solera Slide Topper Access Bracket

NOTE: The Solera Slide Topper Access Bracket can be
installed in two different positions. The lower position (Fig.11A),
first extrusion from the top of the access bracket, is used
for regular clearance. The higher position (Fig.12A), second
extrusion from the top of the access bracket, is used if the
slide topper requires extra clearance.
NOTE: If installing the slide topper access plate on the
T-molding, see "Installing Solera Slide Topper Access Plate"
section (Fig.9), use the first extrusion from the top of the access
bracket method (Fig.11A).
1. Slide an access bracket onto an access plate at the
appropriate position (Fig.11 or Fig.12) at both ends of the
slide room.
access
plate
Fig.11
6
CCD-0002641
A
access bracket
Rev: 08.31.20