Assemble The Extension Rod And Cap; Installing The Solera Slide Topper Access Plate - Lippert Components Solera Slide Topper with Access Plates Installation And Owner's Manual

Assemble the Extension Rod and Cap

1. Slide the extension rod (Fig.4A) into the spring head
assembly torsion arm (Fig.4B), aligning the fastener
locations (Fig.4).
2. Slide the spring head assembly torsion arm end cap
(Fig.4C) into the extension rod (Fig.4A), aligning all three
fastener locations (Fig.4). Fasten using the provided
1/4" - 20 x 5/8" slotted pan head, self-tapping screw (Fig.5).
3. Repeat steps 1 and 2 for the opposite end.
A
Fig.5
Fig.6
lci1.com
B
fastener locations
574-537-8900
Solera
with Access Plates
Installation and Owner's Manual
(For Aftermarket Applications)

Installing the Solera Slide Topper Access Plate

NOTE: If the access plates are already pre-installed,
part number 768004 (black) or 768005 (white) will not be
needed for this installation. Proceed to Installing the Solera
Slide Topper Access Bracket section.
NOTE: The access plate (Fig. 7) can be mounted with the
flat edge (Fig. 7A) at the top or bottom, depending on which
option allows for a more square installation on the unit.
C
Fig.7
1. Install the access plate below the T-molding (Fig.8) or on
the T-molding (Fig.9).
A. If installing below the T-molding, start on one side of
the front of the slide-out by placing one of the two access
brackets (Fig.8A) against the bottom of the T-molding at
the top corner of the slide-out (Fig.8B) as close to the
corner as possible. Keep the mounting bracket parallel
with the bottom edge of the T-molding.
C
B
D
Fig.8
5
Slide Topper
®
A
A
CCD-0002641 Rev: 08.31.20