Toro REELMASTER 6700-D Operator's Manual page 39

Note: Backlapping speed may be increased by moving the
height-of-cut selection knob toward to "A". Each position
will increase speed 60 rpm. After changing selector, wait
30 seconds for the system to respond to the new speed tar-
get.
4. Make initial reel-to-bedknife adjustments appropriate for
backlapping on all cutting units that are to be backlapped.
5. Start the engine and run it at idle speed.
DANGER: To avoid personal injury, never place your
hands or feet in the reel area while the engine is run-
ning. Changing engine speed while backlapping may
cause the reels to stall. Never change engine speed
while backlapping. Only backlap at idle engine speed.
Never attempt to turn reels with your hand or foot
while the engine is running.
6. Select either the front or rear on the backlap switch to
determine whether front or rear reels will be backlapped.
DANGER: To avoid personal injury, be certain that
you are clear of the cutting units before proceeding.
7. Move the Enable/Disable switch to the Enable position.
Move the Lower Mow/Lift control forward to start back-
lapping operation on designated reels.
8. Apply lapping compound with the long-handle brush sup-
plied with the machine. Never use a short-handle brush.
9. If the reels stall or become erratic while backlapping, the
reel control light will begin to blink and the reels will turn
off. If this occurs, turn the height-of-cut. selection knob
one position closer to "A". Then, toggle the
Enable/Disable switch to the Disable position followed by
the Enable position. To resume backlapping, move the
Lower Mow/Lift control lever forward.
10. To make an adjustment to the cutting units while backlap-
ping, turn the reels OFF by moving the Lower Mow/Raise
lever rearward; move the Enable/Disable switch to Disable
and turn the engine OFF. After adjustments have been
completed, repeat steps 5–9.
11. Repeat this procedure for all cutting units to be back-
lapped.
12. When you've completed the backlap operation, return the
backlap switch to OFF, lower the seat and wash all lapping
compound off the cutting units. Adjust the cutting unit reel
to the bedknife as needed.
Figure 50
1. Tie rod clamps
Figure 51
1. Fuses
IMPORTANT
USE CORRECT FUSES.
WRONG FUSES CAN CAUSE
DAMAGE TO CONTROLLER AND
VOID WARRANTY.
CONTROLLER
LOGIC
2A
ACCESSORY
POWER
7.5A
OPTIONAL
LIGHTS
10A
CONTROLLER
POWER (2)
15A
CONTROLLER
POWER (1)
10A
IGNITION
SWITCH
20A
CONTROLLER
POWER (1)
10A
CONTROLLER
POWER (1)
10A
94-6348
39