Toro REELMASTER 6700-D Operator's Manual page 32

Compressed Air Method
A. Blow compressed air from the inside to the outside
of the dry filter element. Do not exceed 689 kPa to
prevent damage to the element.
B. Keep the air hose nozzle at least 5 cm from the filter
and move the nozzle up and down while rotating the
filter element. Inspect for holes and tears by looking
through the filter toward a bright light.
5. Inspect the new filter for shipping damage. Check the
sealing end of the filter. Do not install a damaged filter.
6. Insert new filter into the air cleaner body. Make sure the
filter is sealed properly by applying pressure to the outer
rim of the filter when installing it. Do not press on the
flexible center of the filter.
7. Reinstall the cover and secure the latches. Make sure the
cover is positioned with THE TOP side up.
8. Reset the indicator (Fig. 31) if it still shows red.
ENGINE OIL AND FILTER (Fig. 35–36)
Change the oil and filter initially after the first 50 hours of
operation; thereafter change the oil and filter every 100 hours.
Before servicing or making adjustments to the machine,
stop the engine and remove the key from the switch.
1. Remove the drain plug (Fig. 35) and let the oil flow into
the drain pan. When the oil stops, install the drain plug
and the new plug seal, Part No. 74-7850.
2. Remove the oil filter (Fig. 36). Apply a light coat of clean
oil to the new filter seal before screwing it on. DO NOT
OVER-TIGHTEN.
3. Add 15W–40 CD oil to the crankcase. Capacity is 5 l
with the filter.
FUEL SYSTEM (Fig. 37 & 38)
Fuel Tank
Drain and clean the fuel tank every 800 hours of operation or
yearly, whichever comes first. Also, drain and clean the tank if
32
CAUTION
Figure 34
1. Air cleaner safety filter
Figure 35
1. Drain plug
Figure 36
1. Oil filter