Toro REELMASTER 6700-D Operator's Manual page 16

Water-in-the-fuel Light (Fig. 10)—Warns of water in the fuel
system.
Low Water Level Light (Fig. 10)—Warns that the coolant
water level is low.
Height-of-Cut Selector Knob (Fig. 11)—Turning the knob to
the appropriate setting informs the electronic controller at
what height-of-cut the machine is being operated so desired
clip may be obtained. See section in manual for operating
instructions. The knob is located under the control panel.
Hour Meter (Fig. 11)—Shows total hours the machine has
been operated.
Backlap Switch (Fig. 12)—Used with the lower mow / raise
control lever for backlapping operation. This switch is located
under seat plate. Refer to Cutting Unit Maintenance,
Backlapping.
Brake Pedals (Fig. 13)—Two foot pedals operate individual
wheel brakes for turning assistance, parking and to aid better
sidehill traction. A locking pin connects the pedals for parking
brake operation and transport.
Parking Brake Latch (Fig. 13)—A knob on the left side of
the console actuates the parking brake lock. To engage the
parking brake, connect the pedals with the locking pin, push
down on both pedals and pull the parking brake latch out. To
release the parking brake, depress both pedals until the park-
ing brake latch retracts.
Seat (Fig. 14)—Seat adjusting lever allows 10 cm fore and aft
adjustment. Seat adjusting knob adjusts seat for operator's
weight. To adjust the seat fore and aft, pull the lever on the
left side of the seat assembly outward. After moving the seat,
release the lever to lock the seat into position. To adjust for
operator's weight, turn the spring tension knob: clockwise to
increase tension, counterclockwise to decrease spring tension
16
Figure 11
1. HOC selector knob
2. Hour meter
Figure 12
1. Backlap switch
Figure 13
1. Brake pedals
2. Parking brake latch
3. Locking pin