Toro REELMASTER 6700-D Operator's Manual page 38

4. Place the drain pan under the brake hub on other side of
the wheel.
5. Remove the plug from the bottom of the hub and allow
the oil to drain.
6. When all oil has drained, re-install the plug in the hub.
7. Add high-quality SAE 85W-140 wt. gear lubrication to
bring the level up to the bottom of the hole and install the
plug.
8. Repeat this procedure on the opposite gear assembly.
REAR WHEEL TOE-IN (Fig. 50)
After every 800 operating hours or annually, check rear wheel
toe-in.
1. Measure center-to-center distance (at axle height) at front
and rear of steering tires. Front measurement must be 1/4
in. less than rear measurement.
2. To adjust, loosen clamps at both ends of tie rods.
3. Rotate tie rod to move front of tire inward or outward.
4. Tighten tie rod clamps when adjustment is correct.
BACKLAPPING
Note: When backlapping, the front units all operate together,
and the rear units operate together.
1. Position the machine on a level surface, lower the cutting
units, stop the engine, engage the parking brake, and
move the Enable/Disable switch to the Disable position.
2. Unlock and raise the seat to expose the controls.
Reels may stall while backlapping. do not attempt to
restart the reels by hand or touch the reels while backlap-
ping. Stop the engine and turn the Height-of-Cut knob
one position toward "A".
3. Open the control cover and turn the height-of-cut selec-
tion knob to position "P".
38
CAUTION
Figure 47
1. Drain/Check plug
Figure 48
1. Drain plug location
Figure 49
(Model 03801 only)
1. Drain plugs (3)