Toro REELMASTER 6700-D Operator's Manual page 26

WARNING: When operating the machine, always use the
seat belt and roll-over protection system together.
Warning System—If a warning light comes on during opera-
tion, stop the machine immediately and correct the problem
before continuing. Serious damage could occur if the machine
is operated with a malfunction.
Mowing —Start the engine and move throttle to FAST so the
engine is running at maximum speed. Move the
ENABLE/DISABLE switch to ENABLE and use the LOWER
MOW/RAISE lever to control the cutting units (front cutting
units are timed to lower before the rear cutting units). To move
forward and cut grass, press the traction pedal forward.
Maintain a speed which does not result in the Reel Control
Light being illuminated. Gradually increase or decrease the
traction speed to ensure proper clip is maintained.
Transport—Move the ENABLE/DISABLE switch to DIS-
ABLE, lock the brake pedals together and raise the cutting
units to the transport position. Be careful when driving
between objects so you do not accidentally damage the
machine or cutting units. Use extra care when operating the
machine on slopes. Drive slowly and avoid sharp turns on
slopes to prevent roll overs. The cutting units should be low-
ered when going downhill for steering control.
Selecting Clip Rate (Reel Speed)—The automatic clip con-
trol programmed in the machine controller requires that it be
told at what height of cut the machine is being operated and
whether the machine is equipped with 5- or 11-blade reels.
Refer to Selecting Clip Rate (Reel Speed.
When the machine is being operated in such a way that it
achieves the desired clip, the Reel Control light will not light.
If it does light, this indicates that the traction speed is too low
or too high for the machine to achieve the desired clip.
26