Toro REELMASTER 6700-D Operator's Manual page 36

hydraulic fluid.
4. Assure the filter mounting area is clean. Screw the filter
on until gasket contacts mounting plate. Then tighten the
filter one-half turn.
5. Start the engine and let it run for about two minutes to
purge air from the system. Stop the engine and check for
leaks.
CHECKING HYDRAULIC LINES AND
HOSES
Inspect hydraulic lines and hoses daily for leaks, kinked lines,
loose mounting supports, wear, loose fittings, weather deterio-
ration and chemical deterioration. Make all necessary repairs
before operating.
ADJUSTING THE TRACTION DRIVE
FOR NEUTRAL (Fig. 44)
The machine must not creep when the traction pedal is
released. If it does creep, an adjustment is required.
1. Park the machine on a level surface, shut the engine off
and lower cutting units to the floor. Depress only the
right brake pedal and engage the parking brake.
2. Jack up the left side of the machine until front tire is off
the shop floor. Support the machine with the jack stands
to prevent it from falling accidentally.
Note: On 4-wheel drive models, the left rear tire must
also be off the shop floor.
3. Start the engine and allow it to run at low idle.
4. Adjust the jam nuts on the pump rod end to move the
pump control tube forward to eliminate forward creep or
rearward to eliminate rearward creep.
5. After wheel rotation ceases, tighten the jam nuts to secure
adjustment.
6. Stop the engine and release the right brake. Remove the
jack stands and lower the machine to the shop floor. Test
drive the machine to make sure it does not creep.
36
Figure 44
1. Pump rod
2. Pump control tube