Maestro MR 590 Owner's Manual page 5

Actions in extreme situations:
- If a device tumbled into water, immediately, unplug the device, not touching to the device or water.
- In case of appearance from appliance of smoke, sparkling, strong smell of a burn isolation, immediately
stop use the device, unplug the device, appeal to the nearest service center.
ATTENTION!
- Be careful while handling the cutting edge of the knife. The knife is very sharp. Be extremely
careful when operating the device when the knife is rotating, as well as when cleaning the knife.
- Do not bring the cut product up to the knife with your hands, but only with a pusher.
- Always disconnect appliance before cleaning, assembling,
disassembling, loading and unloading products. Perform assembly and disassembly only
after full stop of moving parts.
Do not use the appliance if the mains cord, the plug or other parts are damaged
In case of failure to observe the rules a danger of serious damages may arise!
Never use any accessories of parts from other manufacture .Your guarantee will become invalid if such
accessories or parts have been used.
-THIS APPLIANCE IS FOR HOUSEHOLD USE ONLY. DO NOT USE THE APPLIANCE FOR ANYTHING OTHER THAN
INTENDED USE.
- Clean all parts of the appliance before the first uses.
- Assemble the thumb guard and the sliding feed table.
- Put the sliding feed table in a vertical position in order to mount it correctly on the support.
- Add the piece holder.
- Select the slicing thickness by turning the adjusting knob.
- Plug in the appliance. The slicer is now ready for use.
- Lay the food to be sliced between the blade and the piece holder.
- Push simultaneously the on/off button and the safety lock with your left hand.
The blade will start rotating. For safety reasons, the appliance only works if both buttons are pushed.
- Push the sliding feed table with your right hand to bring the food to the blade.
- To avoid food sticking to the appliance, you can moisten the blade with a wet towel beforehand. This also
allows you to slice more easily.
- Always use the piece holder when slicing small parts.
Operation guidelines
EN
5