ABB FSO-12 User Manual page 218

218 Installation checklists
Check
MECHANICAL INSTALLATION (See chapter
Unpacking.)
The ambient operating conditions are within the allowed range.
Drives with separate inverter and supply units: Make sure that you have installed the
FSO module in the inverter unit.
The FSO module is fastened properly and the grounding screw is properly tightened.
FSO data cable and STO cable are properly installed and connected.
Packing materials and tools have been removed from the installation area.
ELECTRICAL INSTALLATION (See chapter
Electrical installation.)
If a PELV power supply is used, its ground has to be in the same potential as the drive
ground.
Appropriate supply (input power) fuses are installed.
Data cable between the drive and the FSO module is routed separately from high power
cables (drive supply and motor cabling).
I/O wiring is appropriately clamped, marked, tightened and protected.
24 V DC power supply is properly connected and secured with strain relief, and the
polarity of the supply voltage connection is correct.
Planning for installation
Planning for installation
and section Installation:
and section Installation: