Using The Ice Cub6 Trays - Whirlpool 8EDZOZK Use And Care Manual

Removing the freezer bin
For proper air movement, keep the freezer bin in
place when the refrigerator is operating.
To remove the bin:
1. Slide bin out to the stop.
2. Lii bin at the front to clear the stop.
3. Slide bin out the rest of the way.
To replace the bin:
1. Place bin on the slides.
2. Make sure the stops clear the front of the
slides.
3. Slide bin in.
Using the ice cube trays
If cubes are not used, they may shrink. The
moving cold air starts a slow evaporation. The
longer cubes are stored, the smaller they get.
To remove ice:
1.
Hold tray at both ends.
2. Twist slightly.
Using the automatic ice maker
(Factory-installed on ED22ZR, optional on EDZOPK and EDZOZK)
If you have the automatic ice maker accessory
(Part No. ECKMF-90). or if you plan to add one
later, there are a few things you will want to
know:
l
The ON/OFF lever is a wire signal arm.
Down . . . to make ice automatically.
up . . . to shut off the ice maker.
NOTE: Do notturn ice m -on
!xnnected to the water sup&. lnstructrons for
Jce maker water sup&m
m
ed to the back of the refrlaerator
cabinet
l
The dial or lever on the side of the ice maker
changes the size of the cubes.
l
Shake the bin occasionally to keep cubes
separated and to obtain increased storage
capacity.
l
It is normal for ice crescents to be attached by
a corner. They will break apart easily.
l
You will hear water running when ice maker is
working. You'll hear ice fall into the bin. Don't
let these sounds bother you.
Raise
signal
arm to
Stop ice
maker.
Lower
signal
arm to
stat-t ice
maker.
On
@%a
L ,)
11