Maximum Dimensions; Firing Rate; Test Boiler; Commercial Boilers - Riello RX 360 S/PV Modulating Operation

4.3

Maximum dimensions

The maximum dimensions of the burner and flange are shown in
Fig. 1.
mm
RX 360 S/PV 443
4.4

Firing rate

The maximum output must not be greater than the maximum
limit of the diagram (Fig. 2).
The minimum output must not be lower than the minimum limit
of the diagram.
The ignition output must be selected from within area A for gas
G20 - G31.
4.4.1

Test boiler

The firing rates were set in relation to special test boilers, accord-
ing to EN 676 regulations.
Technical description of the burner
20069631
A B C
417 675
A
E F
371 580
WARNING
Thermal power – kW
4.4.2

Commercial boilers

The burner-boiler combination does not pose any problems if the
boiler is EC type-approved.
If, however, the burner is to be used with a commercial boiler that
has not been EC approved and/or its combustion chamber di-
mensions are distinctly smaller, consult the manufacturer.
You are advised to use this burner for boilers with a frontal circu-
lation of the flue gases.
9 GB
G H
410 144
The firing rate (Fig. 2) has been obtained at an
ambient temperature of 20 °C, at a barometric
pressure of 1013 mbar (about 0 m a.s.l.).
Fig. 1
I L
306 134
Tab. C
20069649
Fig. 2
20068189