Sd Card Slot (Future Enhancement) - ADT RC845 Quick Installation Manual

ADT HD Indoor Camera
Quick Installation Guide
Component
DC Power Input
Power LED
Network/Wireless
LED
(Green, Amber)
WPS/Reset Button
microSD Card Slot (Future Enhancement)
On the side of the camera is a small plate held in place with a retaining screw.
Beneath this cover is a microSD card slot that will be used in a future software
release.
Note: As the microSD card slot is not functional at this time, please do not
remove this protective cover.
RC845 Indoor Full HD Camera Installation Guide
Description
Connect the supplied 12V power adapter here. Do not
use other power adapters; doing so may damage the
camera.
On: (Green) Power on.
Blinking: (Green/Amber)The power LED will blink
green/amber after initial startup is completed. This
indicates that the Soft AP OR WPS PIN mode is ready.
Off: Wireless network is not connected, or camera is not
sending/receiving data.
On: (Green) Network connection is available.
Blinking: (Green) Data is being transmitted or received
via wired/wireless connection.
On: (Amber) If the LED is on for 5 seconds and then
turns off, the WPS function has failed.
Blinking: (Amber) The WPS connection is in progress.
This button serves two functions on the camera.
WPS PIN Mode: When pressed and held for 5 seconds
during the Pulse enrollment process, the camera
creates an encrypted secure wireless connection.
Reset: When pressed and held for 15 seconds, the
camera reboots and settings are restored to default
values.
Figure 1-3 microSD Card Slot Location
Introduction
FCC ID: P27RC845
5