Table of Contents
Advertisement
Web Server
Module Description
This text will appear in email messages when email alerts are enabled as well as on the Control Page.
This field may be up to 35 characters long.
Control Page Refresh Rate
Number of seconds between updating the control page with the current status of the device.
INPUT 1 & INPUT 2
Description
This text is used to describe the function of the selected input. The text appears to the left of
corresponding input status on the Control Page, and in email messages when email alerts are enabled.
This field may be up to 24 characters long. Enter a descriptive name such as "Stockroom Door".
On Status Text
The text in this field specifies the test that will be displayed in the Control Page and in email messages
when the input is ON (switch is closed). Up to 15 characters may be entered in this field. Enter a
descriptive status such as "Door is Open"
On Status Color
This field specifies the color that will be displayed on the Control Page when the input is considered On.
Options are Green, Red, Yellow, Blue and Grey.
Off Status Text
The text in this field specifies the test that will be displayed in the Control Page and in email messages
when the input is Off (switch is open). Enter a descriptive status such as "Door is Closed"
Off Status Color
This field specifies the color that will be displayed on the Control Page when the input is considered Off.
Options are Green, Red, Yellow, Blue and Grey.
Priority (Only available in Slave mode)
When alert messages are sent in slave mode to an X-600M, this setting determines how the X-600M
processes digital events. If Low, the X-600M processes the events with it's normal 3-second scan loop. If
High, the X-600M processes the event immediately.
Email Alert
Simple email messages can be sent in response to changes in the digital inputs. This setting is used to
specify what conditions, if any, will cause email messages to be sent.
•
No email Messages: No email messages will be sent due to input conditions.
•
Send email when Input On: Email notifications will be sent when the input is on.
•
Send email when Input Off: Email notifications will be sent when the input is off.
•
Send email when Input Changes: Email notifications will be sent when the input turns on or off.
Up to three email addresses can be assigned. The same message is sent to each email address. For
email notification to work, the XW-111 must have a properly configured network connection and a SMTP
server must be defined.
Page 30
XW-111™ Wi-Fi Digital Sensor Users Manual
Xytronix Research & Design, Inc.
Advertisement
Table of Contents
