Table of Contents
Advertisement
Web Server
Section 3: Web Server
The internal web server presents two classes of web pages; Setup pages and Control pages. Setup
pages are used by an installer to provision and configure the XW-111. The Control page displays
measurement and status information for the user.
To access the setup pages, enter the following URL in the address bar of your web browser:
http://192.168.1.2/setup.html
To access the control page, enter the following URL in the address bar of your web browser:
http://192.168.1.2
The internal web server is enabled by default in stand-alone mode and disabled in slave mode. If you
wish to access the web server when it is disabled, press and hold the WPS button for 10 seconds. This
will temporarily enable the web-server for five minutes or until the unit is rebooted.
Note that if you are accessing the unit as an access point, the above IP address will work even if you
have changed the IP address or port in the setup pages. If you are accessing the unit through the
network after it has been configured (and the web server remains enabled) you will need to enter the IP
address that was assigned to the device.
If the XW-111 has been added to a network using WPS, it will use DHCP and you will need to enter the
IP address assigned to it. This can be found in the DHCP server, or by using mDNS. The mDNS name is
http://xw-111.local/
3.1 Main Tab
This is the initial page that is displayed
when setup.html is entered in the
address bar of the browser. It displays
model and serial number information,
and has navigation tabs which allow
access to the configuration and setup
settings.
Page 10
XW-111™ Wi-Fi Digital Sensor Users Manual
Xytronix Research & Design, Inc.
Advertisement
Table of Contents
