Whirlpool TGR88W2B Use And Care Manual page 30

PROBLEM
Self-Cleaning
cycle will not
operate
POSSIBLE CAUSE
SOLUTION
The Oven Selector and Oven Set both the Oven Selector and Oven
Temperature Control are not Temperature Control to CLEAN.
set
to CLEAN.
The range clock does not
Reset clock to show the correct time
show the correct time of day. of day. (See page 11.)
The Lock Lever is not in the Move Lock Lever all the way to the
CLEAN positio~all the way right.
to the right.
The Start Time Dial does not
show the correct time of day
or the knob is not all the
way
Out.
Reset the Start Time Knob to show
the correct time of day. Pull knob out
all the way.
The Stop Time Dial is not set
See Step 3 in "Setting the controls"
ahead to the time you want
on page 21 for proper setting instruc-
the self-cleaning cycle to stop.
tions.
Cooking results
The range is not level. Level range. (See Installation Instruc-
are not what you
tions.)
expected
The oven temperature seems Adjust the oven temperature control.
too low or too high.
(See "Adjusting the oven temperature
control" on page 13.)
The oven was not preheated
as the recipe calls for.
Preheat oven if called for in recipe.
The recipe has never been
Use only tested recipes from a
tested or is not from a reliable reliable source.
source.
The pans are not the type or
size recommended in the
recipe.
Refer to a reliable cookbook for
recommended pan type and size.
There is not proper air
circulation around pan when
baking.
Allow 1 Yz to 2 inches (4-5 cm) on all
sides of the pans for air circulation.
There must be a minimum space of
1 inch (2.5 cm).
Flame size does not fit the
cooking utensil being used.
When broiling, you have not
completely closed the oven
door.
Adjust flame size to fit cooking
utensil.
Completely close oven door.
30