Whirlpool TER50W0D Use And Care Manual page 32

PROBLEM
CAUSE
The Self-Cleaning cyble
will not operate
l
You have not set the Oven Selector and Oven Tempera-
ture Control Knob to CLEAN.
l
The range clock does not show the correct time of day.
Reset clock. (See page 12.)
l
The Lock Lever is not in the CLEAN position - all the way
to the right.
l
The Start Time Knob does not show the correct time of
day or the knob is not all the way out.
l
The Stop Time Knob is not set ahead to the time you want
the Self-Cleaning cycle to stop. See Step 3 in "Setting the
controls" on page 23 for proper setting instructions.
Cooking results are not
what you expected
l
The range is not level. (See Installation Instructions.)
l
The oven temperature seems too low or too high. See
"Adjusting the oven temperature control" on page 14 to
adjust oven temperature.
l
You did not preheat the oven before baking (if called for
in recipe).
l
The recipe you are using may need to be altered to
improve the taste or appearance of the food.
l
You are using a pan that is not the correct type or size.
Refer to a reliable cookbook or recipe for recommended
pan type and size.
l
There is not enough air space around pan when baking.
Allow 1 l/2 to 2 inches (4-5 cm) of air space on all sides of
pan. There must be a minimum space of 1 inch.
l
The cooking utensil is too large or too small for the
surface unit being used. Pan should be the same size
or slightly larger than the surface unit being used.
If none of these items was causing your problem, see "Requesting Assistance or Service"
on page 33.
32