Whirlpool SS385PEE Use And Care Manual page 33

PROBLEM
Burner flames
lift off ports, are
yellow, or are
noisy when
turned off
Burner makes
popping noise
when on
The control
knob(s) will
not turn
Self-Cleaning
cycle will not
operate
Cooking results
are not what
you expected
"F-" shows on
the display
IF Y O U NE E D ASSISTAN CE O R SERVICE
POSSIBLE CAUSE
Air/gas mixture is incorrect.
Burner is wet from washing.
You are not pushing in before
turning.
During a delay start the
range clock does not show
the correct time of day.
A delayed start time has
been set.
The door is not shut.
The range is not level.
The oven temperature seems
too low or too high.
The oven was not preheated
as the recipe calls for.
The pans are not the type or
size recommended in the
recipe.
There is not proper air circula-
tion around pan when baking.
Flame size does not fit the
cookware being used.
When broiling, you have not
completely closed the oven
door.
The flow of combustion and/
or ventilation air to the range
is blocked.
SOLUTION
Contact an authorized service
technician to check air/gas mixture.
Let dry.
Push control knob(s) in before turning
to a setting.
Reset clock to show the correct time
of day. (See page 11.)
Wait for the start time to be reached
or cancel and reset the control.
Make sure the oven door is
completely closed.
Level range. (See Installation
Instructions.)
Adjust the oven temperature control.
(See "Adjusting the oven temperature
control" on page 14.)
Preheat oven if called for in recipe.
Refer to a reliable cookbook for
recommended pan type and size.
Allow 1 1 ⁄ to 2 inches (4 to 5 cm) on
2
all sides of the pans for air circulation.
Adjust flame size to fit cookware.
Completely close oven door.
Remove blockage to airflow to and
around range.
Call for service. (See Step 3 on
page 38.)
33