General Cleaning - Upholstery; General Cleaning - Plastic Table Tops; General Infection Control - Champion 54P Series Operating Instructions And Service Manual

Power/heat/massage recliners

Hide thumbs Also See for 54P Series:

Operating instructions and service manual (32 pages)

Table Of Contents

Table of Contents

REGULAR CLEANING: Remove excess soil with a damp non-abrasive cloth. Use a soft white

cloth and solution of mild liquid soap or water based cleaner and water. Rinse all cleaning agents

thoroughly with water and dry with a soft cloth.

IMPORTANT: For specific cleaning instructions, please see manufacturer's cleaning

instructions.

CAUTION: Do not use cleaners marked "for hard non-porous surfaces only" unless

approved by the upholstery manufacturer. Such use may cause surface deterioration.

CAUTION: Pretest any cleaning method or agent in a small hidden inconspicuous

area.

STAIN REMOVAL: For best results treat all stains immediately. Remove any fluids by blotting

with a clean, colorfast, absorbent cloth. Flush stain with water and dry with clean cloth. Remove

as much of the solid or semi-solid substances as possible using a flat object. After removal,

vacuum thoroughly using the proper attachments before cleaning with an agent. Clean stains or

spots from the edge of the stain working towards the center.

CAUTION: Do not use strong solvents such as Picrin

damage your table top.

CAUTION: Compounds that are safe to use on the vinyl surfaces of your chair may

not be appropriate for cleaning your table top.

It is always easier to clean the table immediately after a spill. When the residue from a spill has

dried on the table, a soft bristle brush may be used to help bring it back into solution. Rinse the

surface with clean water. For residue that is not readily soluble in bleach and water, try hot water

and dish washing liquid. Rinse and use absorbent material to remove as much liquid as possible.

You may also try rubbing alcohol, applying a small amount of alcohol with a cloth, ribbing the

dried-on residue. It may take several applications to dissolve the residue.

INFECTION CONTROL: A solution of up to 10% bleach and water may be used. After using

bleach solution be sure to rinse area with a soft cloth moistened with clear water and let dry.

Bleach solutions not completely removed can fade the material. Never use bleach in full strength

to clean these materials. Information in regard to the strength of bleach solution from the vinyl

manufacturer is meant to establish an upper limit beyond which damage might occur.