Power Connections - Champion 54P Series Operating Instructions And Service Manual

Clips
Actuator Cable
Handset Cable
Remove Cables:
1. Remove the cable lock. This may require a small screwdriver to undo the clips on the
control box.
2. Pull the desired cable out of the control box. The power cable has a clip that may require a
screwdriver to release.
Install Cables:
1. Insert each cable into the port shown above. Some of the connectors have a guide pin for
alignment.
2. Install the cable lock over the cables and make sure all three clips have locked in place.
This prevents the cables from being pulled out accidentally.

POWER CONNECTIONS

Guide Pin Slot
Cable Lock
Battery Cable
Power Cable
(24)
OM000PI PI Manual REV 5 080119
Control Box
Fuse Port
(2 extra fuses
in here.)