Ring Gear Installed
FIGURE 13.
Place the ring gear assembly (P/N 063-4001-011) over the female spline adapter with the V-ring facing
4.
down and the holes in the ring gear aligned with the holes in the female spline adapter.
Spacers and Male Spline Installed
FIGURE 14.
Place the two 1/2" spline spacers (P/N 107-4001-018) on the ring gear assembly, aligning the holes in the
5.
spacers with the holes in the ring gear assembly.
Align the bolt holes in the male spline adapter with the holes in the spline spacers.
6.
Install and tighten the #10-24 x 2-1/2" screws (P/N 311-0068-200) to secure the male spline adapter, ring
7.
gear, and spacers to the female spline adapter.
Manual No. 016-5030-062 Rev. A
Mechanical Drive Installation
15