Sam Cook Masterchef Line Executive PSC-40 User Manual page 31

ingredients through the hole, and then
replace the plug.
12. Aft er mixing the contents of the jug (when
the set program is fi nished or aft er pressing
the STOP butt on (C), turn off the appliance
by pressing the POWER butt on (A) and pull
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
INSTRUCTIONS FOR USE
1. To achieve the opti mum effi ciency, put the
required ingredients into the blender jug in
the following order: liquids, fresh ingredi-
ents, yoghurt and ice cream.
2. While operati ng maintain safe distance
from the appliance (min. 20 cm).
3. Before switching on the machine, always
press fi rmly the cover ⑥, so you can freely
remove the cap ⑧ and put the ingredients
through the opening at the top of the cover
while mixing.
4. When processing hot drinks, start from low
speed and then go to high speed. When
there is too much food content inside the
PULSE
blender jug, use as the fi rst functi on
to crush the products.
CLEANING AND MAINTENANCE
1. Before cleaning, make sure that the appli-
ance is switched off and disconnect it from
the power source.
2. Each ti me before and aft er using, disas-
semble the appliance and wash its parts in
warm water with detergent, rinse and dry
them thoroughly.
the power plug out of the electrical mains
socket.
ATTENTION! Before pouring out the content
of the jug wait unti l the knife stops rotati ng!
NOTE! Some products e.g. ice cubes should
be chopped using the PULSE functi on several
5. Every few seconds check the consistency
of the mixed ingredients.
6. Do not exceed the maximum permitt ed
working ti me of the appliance given in the
user manual.
7. If the motor stops, immediately fi nish mixing
or reduce the amount of ingredients in the
jug.
8. To grind ice cubes add a small amount of
water.
9. Do not remove the jug from the housing
when the appliance is in use.
10. Do not insert any objects into the jug
during mixing.
11. If food is pushed to the wall of the the jug
while mixing, this means that the speed
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
3. They should not be used in washing ma-
chines.
4. Cleaning the blender jug: fi ll the jug with
water, press PULSE
onds and then turn it on and rinse with
water.
ti mes. To use the PULSE functi on, press and
and hold the PULSE butt on (D). Do not start
the motor for more than 3.5 minutes, because
it may become over heated. Aft er these
3.5 minutes stop the appliance and wait unti l
it cools down.
is too high and should be decreased. On
the other hand, if food is moving over the
blade, this means that the rotary speed is
too low and should be increased.
The appliance is equipped with an overload
safety switch ⑮ to protect the motor
against overload. If the appliance is over-
loaded, wait unti l the motor is cooled down,
press the butt on ⑮ to restart the appliance
and then turn on the appliance.
If the engine sti ll does not start, this
means that additi onal thermal protecti on is
acti vated - wait for some more ti me before
starti ng.
5. Use sponge or cloth to wipe the jug and
cover, dry them thoroughly to prevent gen-
erati ng odours or the growth of bacteria.
butt on (D) for 10 sec- 6. Periodically check all operati ng compo-
nents of the appliance before using them.
Do not use the blender if the blades got
stuck or rotate with diffi culty. Turn them
counter-clockwise to check if they operate
3 1