Lift-Up Cooktop - Whirlpool RS313PXY Use And Care Manual

3. Hold the surface unit as level as possible with
the terminal just started into the receptacle.
Push the surface unit terminal into the
receptacle.
4.When terminal is pushed into the receptacle
as far as it will go, push down the edge of
the surface unit opposite the receptacle.
Make sure surface unit is properly positioned
and level.
NOTE: Reflector bowls reflect heat back to the
utensils on the surface units. They also help catch
spills. When they are kept clean, they reflect heat
better and look new longer.
If a reflector bowl gets discolored, some of your
utensils may not be flat enough, or some may be
too large for the surface unit. In either case, some
of the heat that's meant to go into or around a
utensil goes down and heats the reflector bowl.
This extra heat can discolor it.
Lift-up cooktop
1. Lift front of cooktop at the center and swing
the support rod up.
2. Carefully lower the cooktop onto the support
rod. Be sure the tip of the rod fits securely in
the cooktop.
Personal Injury Hazard
Be sure the rod is held securely. The
cooktop could accidentally fall and
injure you.
Product Damage Hazard
Do not drop the cooktop. Damage can
result to the porcelain and the cooktop
frame.
3. Wipe with a sponge and warm, soapy water.
Use a soapy steel-wool pad on heavily soiled
areas.
4. To lower cooktop, lift cooktop at the center
and swing support rod back and down into the
storage position. Lower the cooktop.
21