Lift-Up Cooktop - Whirlpool RM975PXK Manual

Receptacle
1. Be sure surface unit controls are OFF.
2. Line up opening in the reflector bowl and
notch in trim ring with the suriace unit
receptacle.
4. While pushing the surface unit terminal into
the receptacle, lift a little on the edge of
the unit nearest the receptacle.
5. When the terminal is pushed into the re-
ceptacle as far as it will go, the surface unit
will fit into the trim ring.
Terminal
3. Hold the surface unit as level as possible
with the terminal just started into the
receptacle.
Reflector bowls reflect heat back to the
utensils on the surface units. They also help
catch spills. When they are kept clean, they
reflect heat better and look new longer.
If a trim ring gets discolored, some of the
utensils used may not be flat enough. Or
some may be too large for the surface unit.
In either case, some of the heat that is meant
to go into or around a utensil goes down
and heats the trim ring. This extra heat can
discolor it.
LIFT-UP COOKTOP
1.
Lift the front of the cooktop at the center 2. Carefully lower the cooktop onto the
and swing the support rod up.
support rod. Be sure the tip of the rod fits in
the notch in the cooktop.
3. Wipe with warm soapy water. Use soapy
steel wool pad on stubborn spots.
DO NOT let the cook-top bump the upper oven when lifting.
DO NOT drop the cooktop. Damage can result.