Table of Contents
Advertisement
Note: Use the bracket template that has been provided with your
trailer kit and follow directions on the template to double check that
the bracket will fit.
Note: Bracket is installed on the front and rear axles for tandem
trailers and on the center and rear axles for tri-axle trailers.
Tools Required
You will need the following tools to install the trailer scale and
deflection sensors:
•
Standard wrench set or adjustable wrench
•
Drill with ¼-inch drill bit, or larger if flush mounted
•
Flush wire cutter
•
Needle nose pliers
•
Grinder
•
Chalk or permanent marker
•
MIG or ARC welder
•
Torque wrench
•
22mm socket
•
Enamel spray paint, any color
•
Tape measure
•
C-clamps (2)
Optional Tool
•
Deflection sensor test box, p/n 1001
2
Advertisement
Table of Contents
