Table of Contents
Advertisement
E
'
ND USER
S MANUAL
D
Figure 2 — Lever G to secure the stabiliz-
ing arms and D for skid arms releasing
WARNING! For operation on uneven
floor please use the rubber-tyred
wheels set (Fig. 3a).
Fig. 3a – Rubber tyred wheels
2.4.
O
C
PERATING
The pedestal has been designed and built
to operate in a dry environment and should
not be used in presence of fine dust or corro-
sive gases.
The pedestal requires the following operating
conditions:
temperature: 5 ÷ 40 °C;
humidity: 30 ÷ 95% without condensa-
tion.
Rev.2 – 10/2016
P70 PLUS PEDESTAL
G
D
ONDITIONS
Cartoni S.p.A. also offers an open-air,
rubber-tyred version of the pedestal, which
should not, however, be exposed to climatic
extremes such as direct hot sunlight or heavy
rain, etc.
2.5. A
SSEMBLY
The column is mounted onto the skid as
follows:
lift the red levers (D) (see Figure 2) to
open the skid arms;
insert column base (B) into the skid
center casting (A) (see Figure 1);
adjust the height of the column, mak-
ing sure that the lower end of the column
does not extend beyond the base of the
skid;
lower lever C (see Figure 4) to secure
the column to the skid;
raise the stabilizing arms and insert
one end (F) of each arm into the seats on
the skid arms (E) (see Figure 3);
lower lever G (Figure 2) to secure the
stabilizing arms;
raise and lower lever C (Figure 4) to
complete stabilisation.
WARNING! When inserting the col-
umn into the base be careful not to put
a foot under the aperture on the skid,
otherwise your foot might be crushed
if you lower the column too far and
fast.
8/18
Advertisement
Table of Contents
