Call Product Support; Get Sf61B Version Information - Honeywell SF61 Series User Manual

Note: Depending on your host configuration (device, Bluetooth version), after a software
reset of your scanner (Reset factory defaults) you may have to re-pair your product
with your host device /application (see the appropriate section in
the

Call Product Support

To talk to Honeywell Product Support representative:
•
•
Before you call Honeywell Product Support, make sure you have the following
information for your SF61B product:
•
•
•
•
•

Get SF61B Version Information

There are two ways to get the firmware version, subsystem versions and decode
version of your SF61B:
•
•
Read "Get Version" Barcodes
You can read Get version barcodes to display your product version information if
your SF61B is connected to a Bluetooth host device / application.
To Get Version Information by Reading Barcodes
1. Connect your SF61B to a Bluetooth host using the appropriate procedure for
2. Run an application that can accept barcode information from your SF61B
42
If you had a Bluetooth connection before the software reset, the SF61B will
disconnect from the host device.
SF61B).
In the U.S.A. and Canada, call 1-800-755-5505
Outside the U.S.A. and Canada, contact your local Honeywell representative. For
help, go to www.honeywellaidc.com
Configuration number ("CN" on the product label)
Serial number ("SN" on the product label)
Firmware version
Sub-system versions
Decode version
Read Get version barcodes and display your product version information on
your host device's screen.
Use EasySet in online setup mode to display your product version information.
your host device /application (see
(Microsoft Notepad if you are using an HID connection for example, or the host
application you use for Bluetooth serial emulation).
and click Contact Us.
Chapter 2, Connect the
SF61 Cordless Scanner User's Guide
Chapter 2, Connect
SF61B).