Advertisement
Quick Links
FX FUSION SC CONNECTOR - 2 mm
INSTALLATION GUIDE
ES: Visite nuestra pagina web www.belden.com/splice-on para obtener el guía de instalación en español.
FR: Veuillez visiter notre site web au www.belden.com/splice-on pour obtenir le guide d'installation
en français.
• Fusion Splicer and Cleaver
• FX Fusion Splice-On installation
Tool Kit
FX Fusion Splice-On Installation Tool Kit contents
Shoulder staps
1.
Scissors
2.
Tweezers
3.
Pen marker
4.
NOTE
: After use, the components should be replaced in their respective locations as shown in the picture of the
open kit.
FX FUSION SC CONNECTOR
2 mm - INSTALLATION GUIDE
Materials
• FX Fusion Splice-On SC Connector kit
• FX Fusion Splice Holder
Waste Bottle
5.
Component checklist
6.
Safety Glasses
7.
Cleaver
8.
PX106501-EN REV C
Fiber/cable stripper
9.
Alcohol Wipes
10.
Installation card
11.
(not shown)
Page 1 of 8
Advertisement
Related Manuals for Belden FX FUSION SC CONNECTOR
Summary of Contents for Belden FX FUSION SC CONNECTOR
- Page 1 FX FUSION SC CONNECTOR - 2 mm INSTALLATION GUIDE ES: Visite nuestra pagina web www.belden.com/splice-on para obtener el guía de instalación en español. FR: Veuillez visiter notre site web au www.belden.com/splice-on pour obtenir le guide d’installation en français. Materials • Fusion Splicer and Cleaver •...
-
Page 2: Security Precautions
= This symbol indicates risks and hazards that may cause eye injuries. = This symbol indicates the presence of a risk that can cause personal injuries or components damages. FX FUSION SC CONNECTOR PX106501-EN REV C Page 2 of 8... - Page 3 Top cover Clamshell open: Just before use, open the sealed bag of the FX Fusion Splice-On SC Connector Kit. FX FUSION SC CONNECTOR PX106501-EN REV C Page 3 of 8 2 mm - INSTALLATION GUIDE...
- Page 4 At the same 17 mm distance make another mark on the Kevlar. It is recommended to remove the NOTE: holder from the splicer. FX FUSION SC CONNECTOR PX106501-EN REV C Page 4 of 8 2 mm - INSTALLATION GUIDE...
- Page 5 Use the guide on the clamshell to mark the tight buffer at 25 mm. 10 mm Cleave the fiber at For both Belden cleavers, the 10 mm mark is where the fiber Strip the tight buffer from that holder ends as shown on red mark.
- Page 6 Fibers end face should be located in between the V-groove and electrodes as shown. Perform the fusion. Bring the splice protection sleeve close to the splicer. FX FUSION SC CONNECTOR PX106501-EN REV C Page 6 of 8 2 mm - INSTALLATION GUIDE...
- Page 7 Example of a good Example of a bad shrinkage: shrinkage: Cut the Kevlar at the 17 mm mark. FX FUSION SC CONNECTOR PX106501-EN REV C Page 7 of 8 2 mm - INSTALLATION GUIDE...
- Page 8 Align the front and outer corners of both housings and snap the 2 parts together. Cut off the excess rod portion of the dust cap. FX FUSION SC CONNECTOR PX106501-EN REV C Page 8 of 8 2 mm - INSTALLATION GUIDE...
Need help?
Do you have a question about the FX FUSION SC CONNECTOR and is the answer not in the manual?
Questions and answers