Belden FiberExpress Brilliance LC-SC-ST Installation Card

Fiber xpress Brilliance
1. Slide Boot on Fiber
4. Mark Buffer at 13 mm
7. Insert Fiber Into Connector up to
the 13 mm Buffer Mark.
Warning: DO NOT try to completely
eliminate residual light
900 m Buffered Fiber
+0.5
8 13
-0.0
To Scale
For complete details on this procedure refer to Installation Guide PX105234.
*
When using a Visual fault Locator (VFL) during termination.
**
When using a field cleaver remove 40 mm of buffer.
A copy of the Guide is supplied with each installation kit or visit www.belden.com
® LC-SC-ST
2. Slide Activator Tab
to the Open Position
5. Clean Fiber
*
MM - Light
MUST go out
8. Create and maintain a bow
with the fiber, while sliding
the Activator Tab
to the Closed Position
SC connector
Activator Tab
©2012 Belden Inc.
All rights reserved.
Printed in Canada
*
Light MUST
appear
*
SM - Light
MUST dim
ST connector
LC connector
Document Number: PX105273
Release: F
Date: May 2012
Installation Card
+ **
3. Strip off 24 2 mm of Buffer
-
6. Align the end of fiber's buffer
at 8 mm and cleave
9. Install Boot on Connector
Boot