Belden FiberExpress Brilliance Installation Instructions

FiberExpress Brilliance
®
900 µm INSTALLATION INSTRUCTIONS
1
Slide boot onto fiber.
5
Align the end of the fiber's buffer at 8
mm and cleave.
9
Do not turn on VFL light source until
fiber is seated and activator tab is
closed. Light from VFL window has no
meaning until activator tab is closed.
Universal
®
2
Slide activator tab to the
open position (towards ferrule).
6
Mark buffer at 13 mm.
10
Multimode - Singlemode -
Light goes out. Light dims. *
*
When using a Visual Fault
Locator (VFL) during termination
3
Strip off 24 ± 2 mm of buffer.
7
Insert fiber into connector up to the 13
mm buffer mark.
11
Install boot onto connector.
4
Clean fiber.
8
Create and maintain a bow
with the fiber, while sliding
the activator tab to the closed position
(towards boot).
To watch a video of
this installation, visit
youtube.com/beldenvid
LC-SC-ST
900 µm Buffered Fiber (To Scale)
50 50
40 40
30 30
20 20
10 10
0 mm 0 mm
For complete details on this
procedure refer to Istallation
Guide PX105234.
*When using a Visual
fault Locator (VFL) during
termintation.
**When using a field cleaver
remove 40 mm of buffer.
A copy of the Guide is supplied
with each installation kit or visit
www.belden.com